Select the job mode for push scan
• Operate the scanner as follows.
1. Press the menu button ( ).
2. Use
or of the cursor button to select "Function Setting".
3. Press the OK button to complete your selection.
4. Use or of the cursor button to select "Job mode".
5. Press the OK button to complete your selection.
6. Use
or of the cursor button to select "USB".
7. Press the OK button to complete your selection.
Scan documents
• Operate the scanner as follows.
Note
• If any documents are left in [Document List], Image Capture Plus cannot receive push scan data.
1. Press the Job button (
).
2. Use or of the cursor button to select a group, and use or to select a job.
• The Group name and the Job Setting name registered in [Scan Button Settings] are displayed.
3. Place the documents on the feed tray.
• When [Touch Free Scanning] is selected, scanning will start when documents are placed on the feed
tray.
• When [Single Touch Scanning] is selected, press the OK button or the Start/Stop button ( ) to
start scanning.
6.4.3 USB Mode
66
To Next Page
Loading...
