Panasonic KX-FP365CX

157
KX-FP365CX / KX-FM388CX
15.1.2.1. Maintenance List
15.1.2.2. Maintenance Cycle
Note:
*
1
These values are standard and may vary depending on usage conditions.
*
2
Refer to Cabinet, Mechanical and Electrical Parts Location (P.193).
No. OPERATION CHECK REMARKS
1 Document Path Remove any foreign matter such as paper. —
2 Rollers If the roller is dirty, clean it with a damp cloth then dry thor-
oughly.
Refer to Document feeder/scanner glass
cleaning (P.165).
3 Platen Roller If the platen is dirty, clean it with a damp cloth then dry
thoroughly. Remove the paper and film cartridge before
cleaning.
—
4 Thermal Head If the thermal head is dirty, clean the printing surface with a
cloth moistened with denatured alcohol (alcohol without
water), then dry thoroughly.
Refer to Thermal Head Cleaning (P.166).
5 Sensors Confirm the operation of the following sensors.
• Document top sensor (SW337) on the Operation Board
• Document set sensor (SW338) on the Operation Board
• Film detection sensor (SW501) on the Sensor Board
• Cover open sensor (SW502) on the Sensor Board
• Paper top sensor (PS401) on the Interface Board
Refer to Maintenance Check Items/Component
Locations (P.156).
6 Glass If the glass is dirty, clean them with a dry soft cloth. Refer to Document feeder/scanner glass
cleaning (P.165).
7 Abnormal, wear and tear
or loose parts
Replace the part. Check if the screws are tight on all parts. —
No. Item Cleaning Cycle Replacement
Cycle Procedure
1
Separation Roller (Ref. No. 137)*
2
3 months
7 years*
1
(31,500 documents)
Refer to How to Remove the Gear Block and
Separation Roller (P.149).
2 Separation Rubber (Ref. No. 10) 3 months
7 years*
1
(31,500 documents)
Refer to How to Remove the Separation Rubber
(P.153).
3 Document Exit Roller (Ref. No. 8) 3 months
7 years*
1
(31,500 documents)
Refer to How to Remove the Operation Board,
LCD, MIC Board and Document Exit Roller (P.152).
4 Paper Exit Rollers (Ref. No. 68, 69) 3 months
7 years*
1
(31,500 documents)
Refer to How to Remove the Paper Exit Roller and
Cassette Lever (P.145).
5 Document Support Roller
(Ref. No.104)
3 months
7 years*
1
(31,500 documents)
Refer to How to Remove the Image Sensor (CIS)
(P.141).
6 Thermal Head (Ref. No. 96) 3 months
7 years*
1
(31,500 documents)
Refer to How to Remove the Thermal Head (P.142).
7 Platen Roller (Ref. No. 54) 3 months
7 years*
1
(31,500 documents)
Refer to How to Remove the Back Cover and
Platen Roller (P.143).
8 Pickup Roller (Ref. No. 46) 3 months
7 years*
1
(31,500 documents)
Refer to How to Remove the Pickup Roller (P.144).