64
KX-FP365CX / KX-FM388CX
Note:
The numbers in the boxes (XXX) indicate the keys to be input for the various test modes.
10.1. DTMF Signal Tone Transmit Selection
When set to ON (=1), the 12 keys and transmission fre-
quencies are as shown.
When set to OFF (=2), the 12 keys and transmission fre-
quencies are as shown.
Note:
After performing this check, do not forget to turn the setting off.
Otherwise, dialing in DTMF signal will not work.
10.2. Button Code Table
DIGITAL
SPEAKERPHONE
RX & TX CHECK
Service Mode [8] [4] [1] Refer to Digital Speakerphone (P.127).
[DIGITAL SP-
PHONE]
PRINT TEST
PATTERN
Service Mode [8] [5] [2] Prints out the test pattern.
Used mainly at the factory to test the print quality.
You can select 1~4. (See Print Test Pattern (P.65))
[SET]
Test Mode Type of Mode Code Function
Operation after code
input
key High Frequency (Hz) key Low Frequency (Hz)
“1” 697 “5” 1209
“2” 770 “6” 1336
“3” 852 “7” 1477
“4” 941 “8” 1633
High (Hz) 1209 1336 1477
Low (Hz)
697 “1” “2” “3”
770 “4” “5” “6”
852 “7” “8” “9”
941
“”
“0” “#”
Code Button Name Code Button Name Code Button Name
04 FAX /START 31 1 47 CALLER ID
05 LOWER 32 2
06 COPY 33 3 64 STATION KEY 1 / BROADCAST
08 DIGITAL SP-PHONE 34 4 65 STATION KEY 2
35 5 66 STATION KEY 3
0A MUTE 36 6 67 STATION KEY 4
0C AUTO ANSWER 37 7 68 STATION KEY 5
0D SET 38 8
1E
[ ] NEXT
39 9
1F
[ ] PREV
3A 0 00 NO INPUT
3B -- STOP
14 RECORD 3C #
16 ERASE 3D REDIAL/PAUSE
18 PLAYBACK 3E FLASH (RECALL)
20 MENU
25 [ + ] VOLUME
26 [—] VOLUME
To Next Page
Loading...
