Panasonic KX-FP365CX

62
KX-FP365CX / KX-FM388CX
9.2. Installing PANA LINK Software
• Install PANA LINK software (CD-ROM) before connect-
ing the unit to a computer with USB cable. If the unit is
connected to a computer with USB cable before install-
ing PANA LINK software, the [Found New Hardware Wiz-
ard] dialogue box will appear. Click [Cancel] to close it.
• The screenshots shown in these instructions are
included for reference only.
• The screenshots shown in these instructions may differ
slightly from those of the actual product.
• Software features and appearance are subject to change
without notice.
1. Start Windows and exit all other applications.
• For Windows 2000, Windows XP and Windows Vista
users, you must be logged in as an administrator in order
to install PANA LINK software.
2. Insert the supplied CD-ROM into your CD-ROM drive.
• If the [Choose Setup Language] dialogue box appears,
select the desired language that you want to use with this
software. Click [OK].
• If the installation does not start automatically:
Click [Start]. Choose [Run...]. Type “d:\setup” (where
“d:” is the drive letter of your CD-ROM drive). Click [OK].
(If you are not sure what the drive letter is for your CD-
ROM drive, use Windows Explorer and look for the CD-
ROM drive.)
The installation will start.
3. Follow the instructions on the screen until all files have
been installed.
4. Connect the unit to your computer when the following dia-
logue box appears.
• If you have already connected it and above dialogue box
does not disappear, plug out and in the cable.
Important notice
If you use Windows XP or Windows Vista, a message may
appear after connecting the unit with the USB cable. This is
normal and the software will not cause any difficulties with
your operating system. You can continue the installation
with no problem. This kind of message is displayed:
• For Windows XP users
“The software you are installing for this hardware has not
passed Windows Logo testing to verify its compatibility with
Windows XP.”
• For Windows Vista users
“Would you like to install this device software?”
To uninstall the software
For Windows 2000, Windows XP and Windows Vista users,
you must be logged in as an administrator in order to unin-
stall PANA LINK software.
1. For Windows 98/Windows Me/Windows 2000:
[Start] → [Settings] → [Control Panel]
For Windows XP/Windows Vista:
[Start] → [Control Panel]
2. For Windows 98/Windows Me/Windows
2000/Windows XP:
Double-click [Add or Remove Programs].
For Windows Vista:
Click [Uninstall a program].
3. Select [PANA LINK] from the list.
4. For Windows 98/Windows Me:
Click [Add/Remove... ], then follow the instructions on
the screen.
For Windows 2000/Windows XP:
Click [Change/Remove], then follow the instructions on
the screen.
For Windows Vista:
Click [Uninstall/Change], then follow the instructions on
the screen.