A SYSTEM INITIALIZE switch
B STATUS Indicator
C POWER switch
Note
• After the PBX is initialized, you can restore system data to the PBX that has been backed up earlier.
For details about backing up and restoring system data, refer to "4.3.3 Maintenance—[2-3] System
Control—System Data Backup & Restore" in the Programming Item List.
• After the PBX is initialized, you must set up the mandatory settings required for the PBX with Easy
Setup Wizard. For details refer to "Connecting to Web Maintenance Console via LAN" and
"3.9.4.1 Easy Setup Wizard".
• When Backup Batteries are connected, make sure it is started as instructed in the documentation for
the Backup Batteries.
Confirming the Trunk Connection
After the PBX starts up, program the PBX and connect trunks to the PBX.
To confirm that the trunks are successfully connected, make a call to an outside party. (Refer to 4.1.2 Calling
an Outside Party)
3.8 Starting the PBX
86 Getting Started
To Next Page
Loading...
