Panasonic KX-NCP1000 - Page 148

FAX Detection Ability
Enables the use of the FAX Detection Ability feature. Since fax signals using a codec other than G.711 cannot
be received accurately at the destination, this feature automatically switches the codec to G.711 to enable
end-to-end fax signal relay over the network.
Default
Enable
Value Range
Disable, Enable
Maintenance Console Location
3.11 [1-1] Slot—Shelf Property - Virtual IP Gateway—GW Settings
Programming Manual References
3.11 [1-1] Slot—Shelf Property - Virtual IP Gateway—GW Settings—Option 1—
IP Codec Priority—1st, 2nd,
3rd
Feature Manual References
None
DTMF
Specifies the method to transport DTMF tones.
Default
Outband (H.245)
Value Range
Inband, Outband (RFC2833), Outband (H.245)
Maintenance Console Location
3.11 [1-1] Slot—Shelf Property - Virtual IP Gateway—GW Settings
Programming Manual References
None
Feature Manual References
None
Payload Type
Specifies the payload type for DTMF tones using RFC2833. Programming this parameter is only necessary if
DTMF is set to Outband (RFC2833).
148 PC Programming Manual Document Version 2009-12
3.11 [1-1] Slot—Shelf Property - Virtual IP Gateway—GW Settings