Panasonic KX-NCP1000 - 1-1] Slot-Card Property - Virtual IPCS

3.20 [1-1] Slot—Card Property - Virtual IPCS
The properties of the V-IPCS card can be specified.
Signaling (PTAP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPCS card to transmit and receive PTAP (Panasonic Telephony
Administration Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Default
39300
Value Range
1–65535
Maintenance Console Location
3.20 [1-1] Slot—Card Property - Virtual IPCS
Programming Manual References
None
Feature Manual References
None
Signaling (MGCP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPCS card to transmit and receive MGCP (Media Gateway Control
Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Default
32727
Value Range
1–65535
Maintenance Console Location
3.20 [1-1] Slot—Card Property - Virtual IPCS
Programming Manual References
None
Feature Manual References
None
Document Version 2009-12 PC Programming Manual 185
3.20 [1-1] Slot—Card Property - Virtual IPCS