Panasonic KX-NCP1000 - Program Launcher-Connect-USB; Program Launcher-Connect-LAN

would prefer to choose from among pre-saved profiles instead, see 2.2.7 Program launcher—Connect—
Profile Setup for more details about creating profiles.
To connect to the PBX by RS-232C
1. From the program launcher, select Connect.
The Login window will be displayed.
2. Select a connection option.
• Select a Profile Name if you want to use a pre-saved profile. This option is only available when one
or more profiles have been previously stored.
a. Select the profile to use from the drop-down list.
b. If the system password for the PBX has not been stored with the profile, enter it.
If the system password has been stored with the selected profile, it does not need to be entered.
• To enter the parameters manually, select the PBX Model and confirm that the RS-232C radio button
is selected.
a. Specify the settings as required. For more details, see the table below.
b. Enter the system password for the PBX.
3. Click Connect.
Connection Settings for RS-232C
Setting
Values Explanation
Port COMx Specify the number of the COM port
assigned to the PC’s RS-232C interface.
Only available COM ports are displayed.
Baud Rate
(bps)
2400, 4800, 9600,
19200, 38400,
57600, 115200
Specify the speed of data transmission.
2.2.4 Program launcher—Connect—USB
Connects to the PBX in Interactive mode through a USB port (USB Module) attached to the KX-DT300 series
or KX-T7600 series DPT.
To connect to the PBX by USB
1. From the program launcher, select Connect.
The Login window will be displayed.
2. Select a connection option.
• Select a Profile Name if you want to use a pre-saved profile.
a. Select the profile to use from the drop-down list.
b. If the system password for the PBX has not been stored with the profile, enter it.
If the system password has been stored with the selected profile, it does not need to be entered.
• To enter the parameters manually, select the PBX Model and confirm that the USB radio button is
selected.
a. Enter the system password for the PBX.
3. Click Connect.
2.2.5 Program launcher—Connect—LAN
Connects to the PBX in Interactive mode through the Local Area Network interface of the PBX.
Document Version 2009-12 PC Programming Manual 31
2.2.5 Program launcher—Connect—LAN