Panasonic KX-NCP1000 - Section 2: Manager Operation

→ DISA—Intercept Timer—Day, Lunch, Break, Night
→ DISA—Disconnect Timer after Intercept
® 6.1
[4-1-1] Wired Extension—Extension Settings—Intercept Destination—
Intercept Destination—When
called party does not answer—Day, Lunch, Break, Night
® 6.10 [4-2-1] Portable Station—Extension Settings—Intercept Destination— Intercept Destination—
When
called party does not answer
—Day, Lunch, Break, Night
® [604] Extension Intercept Destination
Walking COS Through DISA
If the caller performs Walking COS (extension number and PIN entry) while hearing a DISA message, the
security mode can be temporarily changed to No Security mode (® 1.9.5 Walking COS). After performing
Walking COS, the following features are available, using the settings of the specified extension:
• Intercom call
• TIE line call
• Trunk call
• Call Forwarding (FWD)/Do Not Disturb (DND) setting (® 1.3.1 Call Forwarding (FWD)/Do Not Disturb
(DND))
• Incoming Call Distribution Group Log-in/Log-out (® 1.2.2.7 Log-in/Log-out)
• Absent Message setting (® 1.19.2 Absent Message)
• Extension Dial Lock (® 1.9.3 Extension Dial Lock)
• Time Service Switching Mode (® 2.2.4 Time Service)
Note
When making a trunk call using Walking COS through DISA, the CLIP number for that call will be that of
the extension seized by Walking COS. (® 1.21.1.2 Calling/Connected Line Identification Presentation
(CLIP/COLP))
DISA Automatic Walking COS
Registered outside destinations such as cellular phones can be automatically recognised as PBX extensions
when
calling
through DISA. When the Caller ID of a received trunk call matches an entry in the System Speed
Dialling Table, the calling telephone is given Walking COS authorisation as assigned to the corresponding CLI
destination extension. Therefore, the "CLI destination" setting in the System Speed Dialling Table is used here
to specify the target extension that the calling telephone will be recognised as for Walking COS.
[Programming Example of DIL Table]
Trunk No.
CLI Destination
Day Lunch ... Day Lunch ...
01 Disable Disable ...
501
(DISA)
501
(DISA)
...
: : : : : : :
"CLI" must be set to Disable, to allow incoming calls to be received by DISA.
[Programming Example of System Speed Dialling Table]
Location Name
Trunk Access +
Telephone Number
CLI Destination
000 J. Smith 912341115678 200
001 : : :
: : : :
Feature Guide 197
1.17.6 Direct Inward System Access (DISA)