EasyManua.ls Logo

Panasonic KX-NCP1000 - Completion of Calls to Busy Subscriber (CCBS)-By QSIG

Panasonic KX-NCP1000
468 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1.31.3 Peer-to-Peer Connection
Description
This PBX automatically establishes peer-to-peer communication between peer-to-peer compatible IP
extensions (i.e., IP-PTs and SIP extensions). Non-peer-to-peer IP extension calls are routed through the
DSP
card.
However, with peer-to-peer calls, the call is routed directly from one IP extension to another without
going through a DSP card. In other words, peer-to-peer calls can be made without using the PBX’s resources.
Conditions
• Peer-to-peer calls can only be made between extensions connected to the PBX through the IPCMPR/
IPCEMPR card.
• The following IP telephones are peer-to-peer compatible for calls between each other:
– KX-NT265 (version 2.00 or later)
*1
– KX-NT300 Series
– KX-NT400
– SIP Extensions
*1
For details about checking the version of the KX-NT265, refer to the Installation Manual.
• Three codecs are used for peer-to-peer calls: G.722, G.711, and G.729A. The speech quality of the codecs
varies as follows: (High) G.722, G.711, G.729A (Low).
When the preferred codec of each party differs, the call will be established using the lower codec. For
example, if the caller prefers G.711 while the called party prefers G.729A, the call will be established using
G.729A.
• G.722 is only available for calls between KX-NT400/KX-NT300 series IP-PTs and some SIP extensions
that support this codec during peer-to-peer communication.
• Through system programming, it is possible to assign a specific type of codec to be used for each extension.
• For SIP extensions, the priority of the codec that will be used can be specified on a SIP extension basis.
• For non-peer-to-peer calls via the DSP card, calls cannot be made or received when all of the card’s
resources are being used.
Installation Manual References
KX-TDE100/KX-TDE200
1.4.3 System Capacity
KX-TDE600
1.3.3 System Capacity
PC Programming Manual References
3.15 [1-1] Slot—Port Property - Virtual IP Extension—Option—
IP Codec Priority
Feature Guide References
1.31.1 IP Proprietary Telephone (IP-PT)
Feature Guide 385
1.31.3 Peer-to-Peer Connection

Table of Contents

Other manuals for Panasonic KX-NCP1000

Related product manuals