To Next PageTo Next Page
Why does my Panasonic Telephone System not store all received calls in the Incoming Call Log?
If some received calls are not stored in the Incoming Call Log of your Panasonic Telephone System, it is because incoming calls via Voice Call/Paging/LCS/Auto Answer cannot be stored. Set at least one of the incoming call types to On.
Why does the battery icon flash on my Panasonic Telephone after charging?
If you charged the batteries fully, but the battery icon continues to flash on your Panasonic Telephone, try cleaning the charge contacts and charge again. If the issue persists, it may be time to replace the batteries with new ones.
What does "CS Busy" mean on Panasonic Telephone?
If your Panasonic Telephone displays "CS Busy", it means the radio channel is busy. Please try again later.
Why can't I dial on my Panasonic Telephone?
If you cannot dial on your Panasonic Telephone, it might be because the number you dialed is restricted by the system, so you should consult your dealer. Alternatively, the key lock mode might be set. To cancel the mode, press the Function button for about 2 seconds. Also, the radio channel might be busy or a radio communication error occurred, so try again later.
Why is my Panasonic Telephone PS not working?
If your Panasonic Telephone's PS does not work, it could be because the battery is empty. In this case, charge the batteries fully. If the PS has been cancelled or not registered, you should consult your dealer.
What does "REGISTER UNIT" mean on Panasonic Telephone?
If your Panasonic Telephone displays "REGISTER UNIT", it means the PS is not registered in the system. Consult your dealer.
What to do if extensions don't work during power failure on Panasonic KX-TD1232 PBX?
If extensions connected to jack numbers 1, 2, 9, 10 for KX-TD816, and 1, 2, 9, 10, 17, 18 for KX-TD1232 do not operate during a power failure, it may be because a digital or analog proprietary telephone (DPT / APT) is connected to the jack. Disconnect the DPT or APT and connect a single line telephone instead. Alternatively, the dialing mode (tone or pulse) may be improper. Try setting the Tone / Pulse switch to the other position.
How to fix speed dialing on Panasonic KX-TD1232 PBX?
If speed dialing or one-touch dialing does not function on your Panasonic PBX, the programming might be incorrect. Ensure that you enter the outside line access number (9, 81 through 88) into programming.
Why Call Transfer is not working on Panasonic KX-TD1232?
If you cannot originate an outside call, transfer a call, or start a conference on your Panasonic PBX, the corresponding CO button might not be programmed on the proprietary telephone. You will need to program the CO button.
What to do if my Panasonic Telephone displays "PS NO CONNECTED"?
If your Panasonic Telephone displays "PS NO CONNECTED", it could be due to several reasons. First, check if the power switch is turned OFF and turn it ON. Second, the PS might be out of range, so try moving closer to the CS. Finally, the radio channel might be busy, or a radio communication error might have occurred, so try again later.
General| Type | Hybrid PBX |
|---|---|
| Max CO Lines | 12 |
| Max Extensions | 32 |
| Power Supply | AC 120V, 60Hz |
| Caller ID | Yes |
| DISA/OGM | Yes |
| SMDR | Yes |
| Operating Temperature | 0°C to 40°C |
