User Programming
User Manual 73
Making another selection within the same program address
• To go to the next selection, press NEXT.
• To go to the previous selection, press PREV.
• To make a specific selection, press SELECT and then enter the number.
Accessing another program address
After pressing STORE, you can access another program by one of the following two methods:
a) To go to the next program address:
• Larger program address
<KX-T7200 series>
Press Soft 1 (SKP+) or VOLUME (DOWN).
<KX-T7400 series>
Rotate the Jog Dial counterclockwise.
• Smaller program address
<KX-T7200 series>
Press SHIFT + Soft 1 (SKP-) or VOLUME (UP).
<KX-T7400 series>
Rotate the Jog Dial clockwise.
b) To go to a specific program address:
Press END, then enter the program address.
Returning to the operation mode
1. Lift the handset while in programming mode.
2. When the Initial Message: USR-PGM NO? is displayed, press the PROGRAM button.
(To display the Initial Message, press END.)
To Next Page
Loading...
