Panasonic KX-TG4500B - Message Alert; Call Screening (Monitoring); Notify Alert

Programmable Settings
For assistance, please visit http://www.panasonic.com/phonehelp 85
10Press {ENTER}.
L Confirmation tone is heard.
In the above example, phone numbers
that start with “111” are restricted for
cordless handsets 1, 2, 8 and the base
unit.
L To store a second call restriction
number, repeat from step 4.
L To return to standby mode, press
{EXIT}.
Canceling the restricted number
Repeat step 1 through step 6 under “To set
up call restriction” on page 84. Press and
hold {CLEAR}, followed by {ENTER}.
Canceling the restricted cordless
handset(s) and/or base unit
Repeat step 1 through step 7 under “To set
up call restriction” on page 84, then press
{<} to select “Ext. #:”. Enter the base
unit and/or cordless handset number(s) by
pressing the keypad key(s) ({0}, {1} to
{8}), then press {ENTER}.
Message alert
When a new message enters the mailbox,
the cordless handset’s antenna flashes
and the F indicator flashes notifying you
of the message. The default is “ON”.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press .
3 Scroll to “Mailbox” by pressing {V} or
{^}, then press .
4 Scroll to “Message alert” by pressing
{V} or {^}, then press .
L The current setting is displayed.
5 Press {V} or {^} to select “On” or “Off”.
6 Press .
L Confirmation tone is heard.
Call screening (monitoring)
While a caller is recording a message in
the general delivery mailbox, you can
monitor the call through the base unit’s
speaker. If more than one line is receiving
a call at the same time, only the first one
can be monitored. You can answer the call
by lifting the handset or by pressing
{SP-PHONE}.
While monitoring a call, you can
temporarily turn the feature OFF by
pressing {MUTE}. The feature will turn ON
again after the call is disconnected.
1 While in standby mode, press {MENU}.
2 Scroll to “Initial setting” by
pressing {<} or {>}, then press
{ENTER}.
3 Scroll to “Mailbox” by pressing {<} or
{>}, then press {ENTER}.
4 Scroll to “Call monitoring” by
pressing {<} or {>}, then press
{ENTER}.
L The current setting is displayed.
5 Press {<} or {>} to select “On” or
“Off”.
6 Press {ENTER}.
L Confirmation tone is heard.
Notify alert
This feature allows the unit to alert a cell
phone/paging device when your mailbox
has received an incoming message from
an outside caller. You can retrieve the
message from a touch-tone telephone
(page 63). First store a cell phone/paging
device number with the base unit or
cordless handset(s), then set the unit to
call the cell phone/paging device.
Example:
Call restriction: 1
Ext.#:
No.: 111
12-----80
Handset
Select
Select
Select
Save
Base Unit
Base Unit Handset