Panasonic KX-TGA660

Block calls without phone number
Yo
u can reject a call without phone
number including “Out of area”,
“Private caller”, or “Long
distance”.
1 MMENUN
M#N M2N M4N M0N
2 M N/M N: Select the desired setting.
MSAVEN MOFFN
Viewing/editing/erasing call block
nu
mbers
1 MMENUN
M#N M2N M1N M7N
2 M N/M N: Select the desired entry.
R T
o exit, press MOFFN.
3 To edit a number:
MEDITN
Edit the phone number.
MSAVEN MOFFN
T
o erase a number:
MERASEN
M N/M N: “Y
es”
MS
ELECTN
MO
FFN
N
ote:
R When editing, press the desired dial
key to add, MCLEARN to erase.
R When viewing, “Block w/o num” is
displayed if the block calls without
phone number feature is turned on.
To turn the feature off: MERASEN
M N MSAVEN MOFFN
Registering a unit
Operating additional units
Additional handsets
Up
to 6 handsets can be registered to
the base unit.
Important:
R See page 6 for information on the
available model.
Registering a handset to the
ba
se unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base
unit, re-register the handset.
1 Handset:
MMENUN
M#N M1N M3N M0N
2 Ba
se unit:
Press and hold MLOCATORN for
about 5 seconds until the
registration tone sounds.
R If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
R The next step must be completed
within 90 seconds.
3 Handset:
Press MOKN, then wait until a long
beep sounds.
Note:
R While registering, “Base in
registering” is displayed on all
registered handsets.
R When you purchase an additional
handset, refer to the additional
handset’s installation manual for
registration.
Deregistering a handset
A
handset can cancel its own
registration (or the registration of
another handset) that is stored to the
base unit. This allows the handset to
end its wireless connection with the
system.
1 MMENUN
M#N M1N M3N M1N
R Al
l handsets registered to the
base unit are displayed.
2 M
N/M N: Select the handset you
w
ant to cancel.
MSELECTN
3 M
N/M N: “Y
es”
MSELECTN
4 MO
FFN
52
For assistance, please visit http://www.panasonic.com/help
Programming