Panasonic KX-TGA660

2 M N/M N:
Select the desired cellular
p
hone.
MS
ELECTN
R T
he call is transferred to the
handset.
Using the other line during a
co
nversation
You can handle a cellular call and a
landline call at the same time. When
another call is being received during a
conversation, the interrupt tone sounds
(page 43), and the 2nd caller’s
information is displayed if you subscribe
to Caller ID (page 53). You can
answer the 2nd call while holding the 1st
call.
Making/answering a cellular call
du
ring a conversation on the landline
1 Press MMENUN during a landline call.
2 M
N/M N: “Hold” MSELECTN
3 To make a 2nd call:
Dial the phone number.
MCELLN
*
1
M N/M N: Select the
d
esired cellular phone.
MSELECTN
*
1
The unit starts dialing when:
– only 1 cellular phone is
registered.
– a specific line is set to make
cellular calls (page 23).
To answer a 2nd call:
MCELLN
R To hold the 2nd call: MMENUN
M N/M N: “H
old”
MSELECTN
4 T
o hang up the 2nd call and return
to the 1st call (landline call), press
MOFFN, then press M
N.
Making/answering a landline call
du
ring a conversation on a cellular line
1 Press MMENUN during a cellular call.
2 M
N/M N: “H
old”
MSELECTN
3 T
o make a 2nd call:
D
ial the phone number.
M N
T
o
answer a 2nd call:
M
N
R T
o
hold the 2nd call: MMENUN
M N/M N:
“H
old”
MS
ELECTN
4 T
o hang up the 2nd call and return
to the 1st call (cellular call), press
MOFFN, then press MCELLN.
During a power failure
Available for:
KX
-TG7641 series (page 4)
When a power failure occurs, the unit
go
es into power supply mode and the
charged handset temporarily supplies
power to the base unit. This allows you
to make and receive landline calls during
a power failure.The base unit will not
perform any other functions. You can
program“Power failure”and the
default setting is“Off”(page xx).
Important:
R Power supply mode will not work if the
battery level of the power supplying
handset is lower than
.
R If
a handset is not placed on the base
unit when a power failure occurs,
“Base no power Press OFF”is
displayed. After pressing MOFFN on
the handset, place it on the base unit
to start power supply mode.
R Do not lift the power supplying
handset from the base unit during
power supply mode.
R Do not touch the handset’s charge
contacts since they will be hot during
power supply mode.
R In case handset battery power runs
out, we recommend connecting a
corded-type telephone (without AC
adaptor) to the same telephone line or
For assistance, please visit http://www.panasonic.com/help
29
Making/Answering Calls Using the Handset