– – –
*1 If you program these settings using one of the handsets, you do not need to
pr
ogram the same item using another handset.
*2 After the Bluetooth device is registered, “Add new device” changes to the
device name.
*3 When the cellular line only mode is turned on, these menus are not displayed
(page 22).
Programming using the direct commands
1 MMENUN M#N
2 En
ter the desired code.
3 Select the desired setting.
MS
AVEN
R T
his step may vary depending on the feature being programmed.
R To exit the operation, press MOFFN.
Note:
R In the following table, < > indicates the default settings.
Feature Code Setting
System
*
1
Page
Caller list
M2N M1N M3N – – 54
Intercom
M2N M7N M4N – – 69
Date and time
M1N M0N M1N – 18
Alarm
M7N M2N M0N M1N:
O
nce M2N: Daily
M0N: <Off>
– 50
Interrupt to
ne
*2
Handset:
M2N M0N M1N
M1N: <O
n> M0N: Off – 33
Base unit:
M
N M2N M0N
M1N
M1N: <O
n> M0N: Off
33
Silent mode
(O
n/Off)
M2N M3N M8N M1N: On M0N: <Off> – 50
Silent mode
(S
tart/End)
M2N M3N M7N <11:00 PM/06:00
AM>
– 50
For assistance, please visit http://www.panasonic.com/help
43
Programming
To Next Page
Loading...
