8.1.2. Handset
Important:
Make sure the address on LCD is correct when entering new data. Otherwise, you may ruin the unit.
H/S key operation H/S LCD
1). Press {MENU}.
2). Select "Settings" using or
then press
{SELECT} or {>}.
{^} {V}
3). Enter "7", "2", "6", "2", "7", "6", "6", "4".
Note: 7262 7664 = PANA SONI
(see letters printed on dial keys)
5). Enter "
ە
", "
ە
", "
ە
", "
ە
" (Address). (*1)
7). Press
{OK} , a long confirmation beep
will be heard.
8).
Press to return to standby mode.
After that, remove and reinsert the batteries. Press the Power button for
about 1 second if the power is not turned on.
6). Enter "
㸨
", "
㸨
" (New Data). (*1)
4). Select "Write EEP" using or
then press
{SELECT} or {>}.
{^} {V}
{OFF}
Default Data
New Data
Service Mode
Read EEP
Write EEP
Set Addr.:
_ _ _ _ _ _
Set Addr.:
Set Addr.:
CLEAR
OK
CLEAR
OK
BACK
BACK
SELECT
{OFF}
{FLASH}
{CALL WAIT}
Dial keypad
To Next Page
Loading...
