Talking to Two Parties
Alternately
(Call Splitting)
When you are talking to one party and have another
party on hold, you can switch the call on hold and the
current call.
1. Press [HOLD/
] during a conversation.
2. Call the second party.
3. Do one of the following, depending on your unit:
For KX-UT113/KX-UT123 users
• Press [HOLD/ ].
For KX-UT133/KX-UT136/KX-UT248
users
• Press [HOLD/
], and then press the green
flashing DN button (flexible button) that
corresponds to the other party on hold.
Note
• For KX-UT133/KX-UT136/KX-UT248, if
Automatic
Call Hold is enabled on your unit, you
do not need to press [HOLD/
]
in step 3. The
call is automatically put on hold when you press
the DN button. For details, consult your
administrator or dealer.
• For details about DN buttons, see "Flexible
Buttons (KX-UT133/KX-UT136/KX-UT248
only) (Page 39)".
Transferring a Call (Call
Transfer)
You
can transfer a call to another destination (extension
or outside party).
To transfer
1. Press [TRANSFER/
] during a conversation.
2. Call the party you want to transfer the call to.
3. Wait until the other party answers to announce the
transfer.
4. Press
.
Note
• If
On-hook Transfer is enabled on your unit, you
can simply go on-hook in step 4 instead of
pressing
. For details, consult your
administrator or dealer.
• If unscreened transfers are supported on your
phone system, step 3 can be omitted. For
details, consult your administrator or dealer.
• For KX-UT113/KX-UT123, if a call is on hold
(Page 33), the transfer operation cannot be
performed.
To do an unscreened (blind) transfer
1. Press
during a conversation.
2. Call the party you want to transfer the call to.
3. Go on-hook.
Note
• For KX-UT113/KX-UT123, if a call is on hold
(Page 33), the transfer operation cannot be
performed.
To Transfer with One Touch
(One-touch Transfer)
(KX-UT133/KX-UT136/
KX-UT248 only)
1. Press the BLF button (flexible button) during a
conversation.
2. Wait until the other party answers to announce the
transfer.
3. Press
.
Note
• If
On-hook Transfer is enabled on your unit, you
can simply go on-hook in step 3 instead of
34 Operating Instructions Document Version 2013-03
Feature Operations
To Next Page
Loading...
