Panasonic KX-UT133

Call Forwarding/Do Not
Disturb
You can have incoming calls automatically forwarded
to another destination. You can also have incoming
calls rejected (Do Not Disturb).
Note
• When Call Forwarding or Do Not Disturb is
enabled,
FWD/DND
appears on the display in
stand-by mode.
To access the FWD/DND settings
1. In stand
-by mode, press
Setting
or [FORWARD/DO
NOT DISTURB/ ].
• If you press [FORWARD/DO NOT DISTURB/
], continue to step 3.
2. Press [ ]
or [
]
to select "FWD/DND Setting", and
then press [ENTER].
3. If the unit has multiple lines, press [
]
or [
]
to select
the desired line, and then press [ENTER].
4. Press [
] or [ ] to select the type of FWD or DND
setting to apply, and then press [ENTER].
5. Configure the settings as necessary (
Page 46).
Logging in to or Logging
out of a Group
(KX-UT133/KX-UT136/
KX-UT248 only)
Logging in to or Logging out of
an ACD (Automatic Call
Distribution) Group
If the SIP server supports ACD and you are assigned
to an ACD group, you can log in to or log out of the
group.
1. In stand-by mode, press the flexible button
assigned as the ACD Log
-in/Log-out button.
Note
• The flexible button's light indicates the status as
follows:
Off: logged in to the ACD group
Red On: logged out of the ACD group
To set/cancel Not Ready mode
or to leave Wrap Up mode
Press the flexible button assigned as the Wrap Up
button.
The status will change as follows:
Ready ® Not Ready
Not Ready ® Ready
Wrap Up ® Not Ready
Note
• The Wrap Up button's light shows the current
status as follows:
Off: Ready mode for incoming calls
Red on: Not Ready mode for incoming calls
Flashing red: Wrap Up mode
38 Operating Instructions Document Version 2013-03
Feature Operations