1. this unit may not cause interference, and
2. this
unit must accept any interference, including
interference that may cause undesired
operation of the unit. Privacy of
communications may not be ensured when
using the unit.
Setting Up the Unit
This
section explains the settings that you can configure
when you start the unit.
Accessing the start-up settings
1. Connect the unit to an Ethernet cable capable of
delivering power (PoE compliant), or use an
optional AC adaptor to supply power.
2. Connect the unit to the network.
3. On the start-up screen, press
.
4. Select the item for the settings you want to
configure.
Start-up menu
You can configure the following start
-up settings:
1. Information Display (Page 49)
View a variety of information about the unit.
2. Network Settings (Page 49)
Assign an IP address in order to connect to the
network and use the unit.
3. Network Test (Page 52)
Confirm the connection of network devices (e.g.,
the SIP server, routers, switching hubs).
4. ECO Mode (Page 45)
Enable ECO mode.
5. Language (Page 48)
If you prefer to use a language other than English,
change your language settings.
6. Restart (Page 52)
Restart the unit for new settings to take effect.
7. Firmware version (Page 52)
Check the firmware version of the unit.
Document Version 2013-03 Operating Instructions 79
Installation and Setup
To Next Page
Loading...
