- 220 -- 220 -
12. Remote Operations - Tethered Recording
Operating multiple cameras
You can operate multiple cameras remotely using “LUMIX Tether”.
The connecting method differs depends on whether you set the camera to a setting for DHCP server or DHCP client to connect.
C
A
A
A
A
B
LAN cable (commercially available)
Router (commercially available)
PC (commercially available)
Example: When the DHCP server is within the LAN and the camera is set to DHCP client to connect.
1 Set the camera to a DHCP client.
●
[MENU/SET] [ ] [ ] [LAN / Wi-Fi] [LAN / Wi-Fi Setup] [IP Address Setting (LAN)] [DHCP Client]
●
If you changed the setting of [IP Address Setting (LAN)], turn the camera off and then on again.
2 Connect all cameras and the router with LAN cables.
3 Connect the router and PC with a LAN cable.
4 Operate “LUMIX Tether” to operate the camera remotely.
●
When Tethered recording using several cameras, it is recommended to set an individual device name for each camera:
[
] [ ] [Device Name]
To Next Page
Loading...
