37
2. Getting Started
[Economy]
This is a function to automatically turn the camera to sleep (power save)
status or turn off the viewfinder/monitor if no operation is performed for a
set time. Reduces battery consumption.
[ ] Select [Economy]
[Sleep Mode] Sets the amount of time until the camera is put to sleep.
[Sleep Mode(Wi-Fi)]
Sets the camera to sleep 15 minutes after being
disconnected from Wi-Fi.
[Auto LVF/Monitor
Off]
Sets the amount of time it takes for the viewfinder/monitor
to turn off.
(The camera is not turned off.)
[Power Save LVF
Shooting]
Puts the camera to sleep when the recording screen is
being displayed on the monitor when automatic viewfinder/
monitor switching is active.
[Time]
Sets the amount of time until the camera is
put to sleep.
[Display]
Sets the screen where the camera is put to
sleep.
[Only Monitor Info.]:
Puts the camera to sleep only when the
control panel (60) is displayed.
[All Live View]:
Puts the camera to sleep from any screen
during recording standby.
• To recover from [Sleep Mode], [Sleep Mode(Wi-Fi)], or [Power Save LVF Shooting],
perform one of the following operations:
– Press the shutter button halfway.
– Set the camera on/off switch to [OFF] and then [ON] again.
• To recover from [Auto LVF/Monitor Off], press any button.
To Next Page
Loading...
