372
13. Menu Guide
Entering Characters
Follow the steps below when the character entry screen is displayed.
1
Enter characters.
● Press to select characters
and then press
until the
character to enter is displayed.
(Repeat this)
• To repeatedly enter the same character,
rotate
or to the right to move the
entry position cursor.
• If you select an item and press , you can perform the following operations:
– [
]: Change the character type to [A] (upper case characters), [a] (lower
case characters), [1] (numbers), and [&] (special characters)
– [
]: Enter a blank
– [Delete]: Delete a character
– [
]: Move the entry position cursor to the left
– [
]: Move the entry position cursor to the right
2
Complete entering.
● Select [Set] and then press .
• A maximum of 30 characters can be entered (maximum of 9 characters
when setting names in [Face Recog.]).
• A maximum of 15 characters can be entered for [
], [ ], [ ], [ ] and [ ]
(maximum of 6 characters when setting names in [Face Recog.]).
To Next Page
Loading...
