Video Settings – Time Code
388
[Time Code Value]
[Reset]: Sets to 00:00:00:00 (hour: minute: second: frame)
[Manual Input]: Manually input hour, minute, second and frame.
[Current Time]: Sets hour, minute and second to current time and sets frame to
00.
[Time Code Mode]
[DF]: Drop Frame. The camera modifies the difference between recorded time
and time code.
• Seconds and frames are separated by “.”. (Example: 00:00:00.00)
[NDF]: Non-Drop Frame. Records the time code without drop frame.
• Seconds and frames are separated by “:”. (Example: 00:00:00:00)
• When the following functions are being used, [Time Code Mode] is fixed to
[NDF]:
– [50.00Hz (PAL)]/[24.00Hz (CINEMA)] ([Synchro Scan])
– 47.95p or 23.98p [Rec Quality]
[HDMI Time Code Output]
Time code information is added to images output via HDMI when recording with
the [ ] mode.
• The time code can also be output via HDMI by setting the mode dial to [ ]
during playback. In the [Setup] ([IN/OUT]) menu, set [Output
Resolution(Playback)] in [HDMI Connection] to [AUTO]. (Î[Output
Resolution(Playback)]: 602)
• The device screen may go dark depending on the connected device.
[External TC Setting]
Synchronize the time code default value with an external device that supports
time code input and output. (ÎSynchronizing the Time Code with an External
Device: 390)
[TC Synchronization]: Selects the input and output for time code signals.
[TC Output Reference]: Sets the timing for time code signal output.
To Next Page
Loading...
