Video Settings – Synchronizing the Time Code with an External Device
395
Synchronize the Time Code of the Camera with That
of the External Device (TC IN)
The initial time code value of the camera is synchronized according to the
time code signal (LTC signal) of the external device.
1
Prepare for time code synchronizing. (ÎPreparations
for Time Code Synchronization: 391)
2
Set [TC Synchronization] to [TC IN].
≥ ¨ [ ] ¨ [ ] ¨ [Time Code] ¨ [External TC Setting] ¨ [TC
Synchronization] ¨ [TC IN]
3
Operate the external device to output the time code
signal.
≥Set the time code count method of the external device to free run,
and output the signal.
≥When synchronized with the time code of an external device, this
camera is in a slave state, and the [ ] of the time code shown
on the screen switches to [ ].
•
In advance, change the [System Frequency] (Î[System Frequency]: 132), [Rec
Quality] (Î[Rec Quality]: 136), and [Time Code Mode] (Î[Time Code Mode]:
388) to match the external device.
To Next Page
Loading...
