Video Settings – Synchronizing the Time Code with an External Device
391
Preparations for Time Code Synchronization
When [Count Up] is set to [FREE RUN] in the [ ] mode, you can
synchronize the initial value of the time code with an external device.
1
Set the recording mode to [ ].
≥Set the mode dial. (ÎSelecting the Recording Mode: 79)
2
Set [Count Up] to [FREE RUN].
≥ ¨ [ ] ¨ [ ] ¨ [Time Code] ¨ [Count Up] ¨ [FREE RUN]
3
Rotate the flash synchro socket cap in the direction of
the arrow to remove.
• Be careful not to lose the flash synchro socket cap.
4
Insert the BNC conversion cable (for TC IN/OUT), and
then rotate the locking screw in the direction of the
arrow to attach the cable.
To Next Page
Loading...
