Connecting to other equipment
- 108 -
Connect the camera to the PC using the USB connection cable A.
• Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause a
malfunction.
Touch [PC].
• When the camera has been connected to the PC with
[USB Mode] set to [PictBridge(PTP)], a message may
appear on the PC’s screen. Select [Cancel] to close the
screen, and disconnect the camera from the PC. Then
set [USB Mode] to [PC] again.
Double-click on [Removable Disk] in [My Computer].
• When using a Macintosh, the drive is displayed on the desktop. (“LUMIX”,
“NO_NAME” or “Untitled” is displayed.)
Double-click [DCIM] folder.
Using a drag-and-drop operation, move the pictures you want to
acquire or the folder storing those pictures to any different folder on
the PC.
Disconnecting the USB connection cable safely
• Proceed with the hardware removal using “Safely Remove Hardware” on the task tray
of the PC. If the icon is not displayed, check that [Access] is not displayed on the LCD
monitor of the digital camera before removing the hardware.
Note
• Turn the camera off before connecting or disconnecting the AC adaptor (optional).
• Before inserting or removing a card, turn the camera off and disconnect the USB
connection cable. Otherwise, data may be destroyed.
To Next Page
Loading...
Need help?
General
