Panasonic Lumix DMC-FP7 - Page 46

Basic
- 46 -
[Calibration]
Adjust the position of the touch panel if a different thing
gets selected from what you touched or touch operation
does not respond.
1 Touch [Start].
2 Touch the orange [4]
mark displayed on the
screen in order with the
stylus pen (supplied)
(5 places).
• A message is displayed once the position is set.
• After setting, close the menu.
• Calibration is not done if correct position is not touched. Touch the [4] mark again.
[Language] Set the language displayed on the screen.
• If you set a different language by mistake, select [9] from the menu icons to set the
desired language.
[Demo Mode]
The approximation amount of jitter detected by
the camera is displayed (when recording only).
([Stabilizer Demo.])
The camera’s features are displayed as Slide Shows.
([Auto Demo])
[Stabilizer Demo.]
AAmount of jitter
BAmount of jitter after
correction
B
A
[Auto Demo]:
[ON] / [OFF]
• The stabilizer function is switched between [On] and [Off] every time [Stabilizer] is
touched during the [Stabilizer Demo.].
• [Auto Demo] has no TV output capability.