Panasonic Lumix DMC-FP7

Advanced (Recording pictures)
- 54 -
 Shutter speed for each ash setting
Flash setting Shutter speed (Sec.)
q
1/60 to 1/1600
@
t
`
Flash setting Shutter speed (Sec.)
[
1 to 1/1600
1 or 1/4 to 1/1600

o
¼
The shutter speed becomes a maximum of 1 second in the following cases.
– When the Optical Image Stabilizer is set to [OFF].
– When the camera has determined that there is little jitter when the Optical Image
Stabilizer is set.
• In Intelligent Auto Mode, shutter speed changes depending on the identied scene.
• In Scene Mode, shutter speed will be different from the above table.
Note
• If you bring the ash too close to an object, the object may be distorted or discolored by
the heat or lighting from the ash.
• When you take a picture beyond the available ash range, the exposure may not be
adjusted properly and the picture may become bright or dark.
• When the ash is being charged, the ash icon blinks red, and you cannot take a picture
even when you press the shutter button fully.
• The white balance may not be properly adjusted if the ash level is insufcient for the
subject.
• When using [Flash Burst] in Scene Mode or when the shutter speed is fast, the ash
effect may not be sufcient.
• It may take time to charge the ash if you repeat taking a picture. Take a picture after the
access indication disappears.
• The Red-Eye Reduction effect differs between people. Also, if the subject was far away
from the camera or was not looking at the rst ash, the effect may not be evident.