Preparation
17
Turning Power on/off
1 Set the power switch to [ON].
• The power indicator 1 lights.
2
Set
the power switch to [OFF].
ª
Power indicator
Lighting:
• When turning the power switch to [ON]
Blinking:
• When the Memory Card/battery door is
opened
• When the card is not inserted
• When no space is left on the card
• When the card is protected during
recording
• When setting the mode dial from the
playback mode to recording mode with
the lens cap attached
• When the remaining battery power is
low (blinking slowly)
• When turning on the power in the recording mode, do not put any obstacle in front
of the lens.
• Please be sure to remove the lens cap before you switch on the camera in
recording mode. If not, the message “REMOVE LENS CAP AND PRESS
BUTTON” appears on the LCD monitor/Viewfinder. Please remove the lens
cap and press 4/[REVIEW/SET] button 2.
• Do not exert any pressure on the lens when it is extended. To clean the lens,
please turn the camera off to retract the lens.
OFF≥≥ON
1,2
OFF≥≥ON
FZ2-PP.book 17 ページ ２００３年９月２６日 金曜日 午後１２時１分
To Next Page
Loading...
Need help?
General
