27
(ENG) VQT3T96
Easily set a suitable exposure (one push AE)
With one push AE, you can easily achieve a suitable exposure setting when the exposure
setting is too bright or too dark. ( , , modes only)
At purchase, one push AE is assigned to the [Fn1] button.
•
The exposure meter is displayed, and the aperture and shutter speed are changed to give
a suitable exposure. Which items of the settings change will depend on the Recording
Mode.
Using the function button
The recording functions etc. registered in the [Fn BUTTON
SET] of the [CUSTOM] menu can be assigned to the [Fn1],
[Fn2] (function) buttons, [Fn3] and [Fn4] icon.
You can use the assigned functions by pressing the buttons for
[Fn1] and [Fn2] and by touching the icons for [Fn3] and [Fn4].
•
To use [Fn2], set the [AF/AE LOCK /Fn2] of the [CUSTOM] menu
to [Fn2].
Select [Fn1], [Fn2], [Fn3] or [Fn4] from the [Fn
BUTTON SET] in the [CUSTOM] menu and
press [MENU/SET].
Select the function you want to assign and
press [MENU/SET].
• Assign your favorite function to [Fn1], [Fn2], [Fn3] and [Fn4].
• Exit the menu after it is set.
How to tell if the exposure is not adequate
•
If the aperture values and shutter speed blink red A when the
shutter button is pressed halfway.
• If the Manual Exposure Assistance is anything other than
when in mode.
1 Set the [Fn BUTTON SET] of the [CUSTOM] menu to [ONE PUSH AE].
•
The initial setting for [Fn1] is [ONE PUSH AE].
2 (When exposure is not adequate) Press [Fn1]
DMC-GX1X&GX1K&GX1PP-VQT3T96_eng.book 27 ページ ２０１１年１０月１３日 木曜日 午後２時５４分
To Next Page
Loading...
