Panasonic LUMIX DMC-LX2

Preparation
16
VQT0Y44
Inserting/Removing the Card (Optional)
• Check that the camera is turned off and
that the lens is retracted.
• Prepare an SD Memory Card (optional),
an SDHC Memory Card (optional) or a
MultiMediaCard (optional).
• Close the flash.
• You can record or play back pictures
on the built-in memory when you are
not using a card. (P17)
1 Slide the card/battery door to
open it.
2 Insert:
Insert the card with the label side
facing the back of the camera until it
clicks and locks.
Remove:
Push the card until it clicks, then pull
the card out upright.
• Check the direction of the card.
• Do not touch the connection terminals on
the back side of the card.
• The card may be damaged if it is not fully
inserted.
3 1 Close the card/battery door.
2 Slide the card/battery door to
the end and then close it firmly.
• If the card/battery door cannot be
completely closed, remove the card,
check its direction and insert it again.
• The card and the data may be damaged
if it is inserted or removed while the
camera is on.
• We recommend using Panasonic’s SD
Memory Card/SDHC Memory Card.
2
1