Advanced
51
VQT0Y44
Taking Pictures using Burst Mode
1
Press and hold the burst mode
button until the burst menu is
displayed.
OFF: No display (canceled)
D: High speed
E: Low speed
F: Unlimited
2
Press e/r or the burst mode
button to switch burst mode
settings.
• When 5 seconds pass without any
operation, the setting selected at the time
is automatically adopted.
3
Press [MENU/SET].
• You can also press the shutter
button halfway to finish.
• You can also use the joystick to perform
steps 2 and 3.
4
Take a picture.
• Hold down the shutter button fully to
activate the burst mode.
n Number of pictures recorded in burst
mode
*The transfer speed of the card has no
effect on the burst speed.
• The number of pictures indicated is when
the shutter speed is faster than 1/60 and
the flash is not activated.
• The burst speed (pictures/second) may
become slower depending on brightness
and other recording conditions.
MENU
OFF
H
L
BURST SHOOTING
SELECT SET
HIGH SPEED
LOW SPEED
UNLIMITED
To select To set
Burst speed
(pictures/
second)
Number of recordable
pictures (pictures)
D
2* max. 3 max. 5
E
1* max. 3 max. 5
F
approx. 1
Depends on the
remaining capacity of the
built-in memory/card.
G H
To Next Page
Loading...
