Advanced
50
VQT0Y44
Optical Image Stabilizer [STABILIZER]
This mode recognizes and compensates for jitter.
1
Press and hold the optical image
stabilizer button A until [
STABILIZER] appears.
2
Press e/r to select the stabilizer
function mode and then press
[MENU/SET].
• You can also use the joystick to perform
step 2.
n Demonstration of the optical image
stabilizer (Demonstration Mode)
When you press q, the demonstration
appears. After the demonstration ends, the
screen returns to the stabilizer function
mode selection menu. If you want to exit
the demonstration halfway through, press
q again.
While the demonstration is displayed, the
optical zoom is fixed to Wide (1×) and the
zoom function cannot be activated.
Moreover, you cannot take pictures.
• The stabilizer function may not work in the
following cases so take special care not to
move the camera when pressing the
shutter button.
–When too much jitter occurs.
–When the zoom magnification is high.
–In digital zoom range.
–When taking pictures while following
subjects in motion.
–When the shutter speed is extremely
slow due to dark conditions or other
reasons.
• In [SELF PORTRAIT] (P64) in scene
mode, the stabilizer function is set to
[MODE2]. In starry sky mode (P67), the
function is set to [OFF]. In these modes,
the camera does not display the menu for
selecting the optical image stabilizer.
• In motion picture mode [i], [MODE2]
cannot be set.
MODE1
(7)
The stabilizer operates
continuously and can assist
during photo composition.
MODE2
(8)
The jitter is compensated for
when the shutter button is
pressed. There is a greater
stabilizing effect.
OFF
()
When image stabilization is not
desired.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
