Preparation
20
VQT0Y44
Setting Date/Time (Clock Set)
n Initial setting
The clock is not set when the camera is
shipped. When you turn the camera on, the
following screen appears.
A: [MENU/SET] button
B: Cursor buttons
1
Press [MENU/SET].
2
Press e/r/w/q to select the date
and time.
C
: Time at the home area
D: Time at the travel destination (P72)
• w/q : Select the desired item.
• e/r : Set date and time.
• Refer to [WORLD TIME] (P72) for
information about setting the local time at
the travel destination area.
• You can press [A] to cancel the operation
without setting the clock.
3
Press [MENU/SET] several times
to close the menu.
• You can also press the joystick to close
the menu.
• Turn the camera off after finishing setting
the clock. Then turn it on and check that
the clock setting is correct.
1Press [MENU/SET].
2Press e/r to select [CLOCK SET] (P93).
3Press q and perform the above steps 2
and 3 for setting.
• You can set the clock from the setup
menu (P21) while in playback mode [Q].
• You can use both the cursor buttons and
joystick for this operation.
• When a fully charged battery has been
inserted for more than 24 hours, the clock
setting is stored (in the camera) for at
least 3 months even if the battery is
removed.
• You can set the year from 2000 to 2099.
The 24-hour system is used.
• If you do not set the date, the date cannot
be printed when you go to a photo studio
for digital printing. (P100)
A
To Next Page
Loading...
Need help?
General
Weight and Dimensions
