Advanced
52
VQT0Y44
• When the flash is activated or [STARRY
SKY] in scene mode is selected, you
can take only 1 picture.
• When the burst mode setting is set to
Unlimited:
– You can take pictures until the capacity
of the built-in memory or the card is full.
– The burst speed will become slower
halfway. When the built-in memory is
used, the burst speed becomes a
maximum of 1 picture approximately
every 6 seconds. However, the exact
timing of this depends on the number of
recordable pictures and the card.
• The focus is fixed in the first picture.
• The ways to control the exposure and the
white balance vary depending on the
burst mode setting. When the burst mode
is set to [D], they are fixed to the
values set for the first picture. When the
burst speed is set to [E] or [F],
they are adjusted each time you take a
picture.
• When the self-timer is used, the number
of recordable pictures in burst mode is
fixed to 3.
• Burst mode is not canceled when the
camera is switched off.
• When the burst mode is activated, the
audio recording function cannot be used.
• When setting auto bracket and the burst
mode simultaneously, auto bracket will be
performed.
• In Burst mode, auto review is activated
even the setting is off. (The picture is not
enlarged.) You cannot change the auto
review setting in the setup menu.
• You cannot use burst mode if you have set
quality to [RAW].
To Next Page
Loading...
Need help?
General
Weight and Dimensions
