Panasonic Palmcoder PalmSight PV-L51 - Page 10

Supplying Power
Caution: To avoid Battery damage:
¢ Charge only with specified charger. * Do not drop or jar Battery.
s Battery can be charged within a temperature range of s Use Battery with specified units only.
10 °C (50 °F) and 35 °C (95 °F). * If Battery is used in extremely high
* Battery is normally warm after charging or just after use. temperatures, a safety device will
* Do not use an insufficiently charged or worn-out Battery. automatically prevent operation.
Safety precautions: To prolong Battery life:
* Do not get Battery near, or dispose of in fire. s While not in use, remove Battery
* Do not directly connect {short circuit) the positive (+) and from the Camcorder and AC Adaptor
negative (~) terminals. and store in a cool, dark, dry place.
* Never attempt to disassemble or reassemble Battery. + Keep Battery terminals clean.
U.S.A. CONSUMERS: ATTENTION:
The product you have purchased is powered by a nickel cadmium battery
which is recyclable. At the end of its useful life, under various state and local
laws, it is illegal to dispose of this battery into your municipal waste stream.
wea Please call 1-800-8-BATTERY for information on how to recycle this battery.
We Mame o d Bey Gard (ational,
Cigarette
Lighter
Socket (12 V)
VCR DC OUT
Connector
Connect AC Adaptor VCR DC OUT to
Camcorder DC IN with supplied DC
Power Cable.
Plug in AC Adaptor.
POWER Lamp lights.
Note:
¢ While the DC Power Cable (supplied) is
connected to the AC Adaptor, the Battery
cannot be charged.
e When not in use, unplug AC Adaptor from
AC outlet. (Adaptor uses 1.2 W of electricity
while plugged in.)
CAUTION:
This unit will operate on 110/120/220/240 V AC.
An AC plug adaptor may be required for voltages
other than 120 V AC. Please contact either a
local or foreign electrical parts distributor for
assistance in selecting an alternate AC plug. We
recommend using the accessory power plug
adaptor (VJSS0070) in an area which has
special AC outlets.
Car Battery Cord Cigarette
(optional) Lighter Plug
1 Connect PV-C16 Car Battery Cord
(optional) to Camcorder DC IN.
Start engine first.
Piug Car Battery Cord into
Cigarette tighter socket.
e lf Car Battery cord fuse needs
replacing, use exact current rating
(in amps).
Note:
e This cord only works in vehicles
equipped with DC 12 V (negative
ground) battery. Check with your car/
truck dealer. Use only specified car
battery cord.
s To avoid blowing the car battery cord
fuse, do step 2 in the proper order.
e Running vehicles must be well ventilated.
s When not in use, disconnect cigarette
lighter plug.
1 0 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts£ panasonic.com
D0000008000900000000005080000090000000000005000
D D