Supplying Power
II €]_iii (:.]ivi _,1"_i *r=t.-fi
This feature completely discharges Battery before recharging begins.
Use after about every 5 charges for optimum Battery performance.
CHARGE Lamp 1
Plug in A__C__.
• POWER Lamp stays on as long as
Adaptor is plugged in.
Place _ into Adaptor.
1 Press _.
The CHARGE Lamp flashes during]
discharge then stays lit until charging
t is complete...._ BATTERY If BATTERY REFRESH is pressed
_I_=="F-_"_'_ 4_ /"1'_i" by mistake, remove Battery from
REFRESH
f Adaptor and reinsert it for normal
charging.
Remove Batten/.
• Charging takes about 7 and 1/2 hours
' when Battery Refresh is used.
• Battery will not operate in extremely high
temperatures.
Caution:
• Charge only with specified charger.
• Battery can be charged within a temperature
range of 50° F (10 ° C) and 95° F (35° C).
• Battery is normally warm after charging or just
after use.
• Do not use an insufficiently charged or worn-
out Battery.
Safety precautions:
• Do not get Battery near, or dispose of in fire.
• Do not directly connect (short circuit) the
positive (+) and negative (-) terminals.
• Never attempt to disassemble or reassemble
Battery.
To avoid Battery damage:
• Do not drop or jar Battery.
• Use Battery with specified units only.
• If Battery is used in extremely high
temperatures, a safety device will
automatically prevent operation.
To prolong Battery life:
• While not in use, remove Battery from the
Camcorder and AC Adaptor and store in a
cool, dark, dry place.
• Keep Battery terminals clean.
U.S.A. CONSUMERS:
1
_for informationon how to recycle this battery. J
ATrENTION:
The product you have purchased ispowered by a nickel cadmium battery which is
recyclable.At the end of its useful life, under vadous state and local laws, it is illegal to
dispose of this battery intoyour municipal waste stream. Please call 1-800-8-BATTERY
11
To Next Page
Loading...
