Copying your Tapes (dubbing)
Source (Playing)
Camcorder
OutAudio/Video I
TV
Before you begin...
• Make Camcorder-VCR connections
(see left).
• Turn both units on.
• Set VCR input signal to LINE.
Please see VCR owner's manual.
• Set Camcorder POWER to VCR.
1
2
3
Insert a pre-recorded tape
into Camcorder and a blank tape with
record tab into VCR.
Press PLAY on Camcorder, then
press STILL at starting point.
Press REC, then STILIJPAUSE on
VCR.
Press STILL on Camcorder and
STILL/PAUSE on VCR again to start
copying,
Recording: 5
VCR Press STOP on both units to stop
copying.
|n
Note:
• Camcorder will only playback tapes
recorded in SP or SLP mode,
• Dubbing may reduce picture quality.
Audio/Video Cable
(supplied)
II LIJ[o] It i (o] iliVAV|I_ilMLo]I I ill llTII
• Turn TV on and tune to VCR
channel (CH3 or CH4).
• Set VCRFL'V Selector on VCR to VCR,
, CAUTION:
Unauthorized exchanging and/or 1
copying of copyrighted recordings may|
be copyright infdngement. J
29
To Next Page
Loading...
