II I_ im[_ii | _]i [1[_ _i
For recording in dim lighting.
Built-in Auto Light
Before you begin...
• Connect Camcorder to power source.
• Set POWER to CAMERA.
Set LIGHT to AUTO.
Light turns onloff automatically according
to lighting conditions.
Or, set LIGHT to ON/OFF manually.
I lX _,_I, r.J _,,.a
12:00:.OOAM
JAN 11999
DANGER:
Use only replacement bulb (PART NO.
VLLW0015) supplied by Panasonic to
reduce risk of fire.
Handle new bulb with cloth or tissue as
skin oils will decrease bulb life.
Remove lens cover and allow bulb to
cool before replacing to avoid possible
burn hazard.
SRc_p_ _E>appears in EVF when Light is on.
J
Caution:
Light becomes hot. Never cover Light while
on.
Before you begin...
• Order Part No. VULS0001 (VLLW0015 and
cushions) for replacement bulb unit.
• Set POWER to OFF.
Press in on both sides of lens
cover and pull straight out and off.
2
Using Tweezers or needle-nose
pliers, carefully remove bulb.
• Take unit to service center if you
need assistance,
Replace bulb using a clean cloth or
tissue.
Replace lens cover.
Note:
• Using Light reduces battery operating time.
• Provide proper ventilation when using Light
extensively in hot environment.
• Using Light when the Camcorder is powered
by a car battery may shorten bulb life.
• Set Light to OFF when not in use.
• Handle bulb gently. Excessive force may
cause bulb to crack.
19
To Next Page
Loading...
Need help?
General