－ 45 －
(3) Waveform graphic display area
(4)Waveform graphic is displayed according to your
setting in Waveform graphic operation and setting area.
When “Measuring condition” “trigger condition” “Vertical
axis/Horizontal axis” tab is selected, you can zoom in
and out a graph with a magnifying glass.
Click the Left
button of the mouse to zoom in and the right button to
zoom out.
When “Measuring condition” “trigger condition” “Vertical
axis/Horizontal axis” tab is selected, you can zoom in
and out a graph with a magnifying glass. Click the left
button of the mouse to zoom in and the right button to
zoom out.
(4) Waveform graphic operation and setting area.
Specify conditions for measuring waveform graphics.
These measuring conditions can be saved in a file.
(See Section 6 “Saving and loading waveform graphic
measuring conditions”.)
<Measurement items tab>
Specify condition for measurement and the sampling cycle.
“Measurement items”: You can measure any of “Command speed” , “Torque” and
“Position error” even at the same time.
Some amplifiers enable any three items to be selected
from the five items (commanded speed, torque, position
error, positioning completion signal and full close
error.)
MINAS-E series enable one item to be selected from
the five items.
“Sampling”: Selects a sampling cycle.
To Next Page
Loading...
