Panasonic PANATERM Ver. 3.7 - Page 47

－ 46 －
6.OPERATION
<Trigger condition tab>
Set the trigger condition.
“Set the trigger of actual speed”: It is valid with check.
“Single trigger”: It is measured only once with check.
Without check it continues to be measured until
you click “Stop”.
“Trigger level”: Set the actual speed to trigger. You can
set plus or minus with .
“Slope”: Set the slope to trigger. Select “Start” or “Finish”.
“Trigger position”: Select where to start trigger for the measuring
period.
<Vertical axis/Horizontal axis tab>
Set the display condition of waveform graphic.
“Y axis”: Set the magnification and position of “Speed”,
“Torque”, “Position error” and “In-position”.
“Auto range”: The magnification and position is automatically
set optimum.
“Initialize vertical axis”: Initialize the display position.
“X axis”: Set the Magnification and position of horizontal
axis (Time axis).