－ 47 －
<Cursor tab>
Set the cursor.
“Display”: Display 2 cursors with check.
“Cursor 1”: Set the position of cursor 1. You can set the position
with the left button of the mouse, too.
Each value of “Time”, “Actual speed”, “Command speed”,
“Torque”, “Position error” is displayed.
“Cursor 2”: Set the position of cursor 2. You can set the position
with the right button of the mouse, too.
Each value of “Time”, “Actual speed”, “Command speed”,
“Torque”, “Position error” is displayed.
“Cursor 2- Cursor 1”:
Difference in values of cursor 1 and cursor 2
of “Time”, “Actual speed”, “Command speed”,
“Torque”, “Position error” is displayed.
“Move cursor 1 to trigger position”:
Move cursor 1 to the position set in “Trigger condition”.
To Next Page
Loading...
