PICTURE menu
Remote control Control panel
See “Navigating through the MENU” on page
16.
See “Menu list” on page
17.
PICTURE MODE
Depending on the projection environment, you can
use these preset parameter settings to optimise image
projection. Press ◄ ► to cycle through the options.
NORMAL CINEMA3
DYNAMIC
CINEMA2
COLOR1
COLOR2 CINEMA1
NORMAL
Setting for a general image,
such as sports programme or TV
games.
DYNAMIC Bright and sharp setting.
COLOR1
Setting for HDTV standard
in ITU-R BT. 709 and color
temperature 6 500 K at the default
setting of the PICTURE menu
items.
COLOR2
Setting for DCDM standard
(SMPTE431-2) and color
temperature 6 300 K at the default
setting of the PICTURE menu
items.
CINEMA1
Setting tuned by top Hollywood
colorists.
CINEMA2 Deeper and more rich color setting
CINEMA3 Vivid and crisp color setting.
NOTE:
It may take a while until the selected mode is stabilized. •
CONTRAST
You can adjust the contrast of the projected image.
Adjust the BRIGHTNESS in advance if necessary.
Lower Higher
Setting range: −64 to +64
BRIGHTNESS
You can adjust the brightness of the projected image.
Darker Brighter
Setting range: −32 to +32
COLOR
You can adjust the color saturation of the projected
image.
Lighter Darker
Setting range: −32 to +32
When
RGB/YP
B
P
R
signal is connected, only available
with the following signals.
1 125 (1 080)/60i 1 125 (1 080)/50i
1 125 (1 080)/60p 1 125 (1 080)/50i
TINT
You can adjust the skin tone in the projected image.
More
reddish
More
greenish
Setting range: −32 to +32
When
COMPUTER signal is connected, only available
with the following signals.
1 125 (1 080)/60i 1 125 (1 080)/50i
1 125 (1 080)/60p 1 125 (1 080)/50i
SHARPNESS
You can adjust the sharpness of the projected image.
Less
sharp
More
sharp
Setting range will vary according to the selected input
signal.
To Next Page
Loading...
