Projection method
You can use the projector with any of the following 4 projection methods. To set the projector in the desired
method, see “INSTALLATION” on page 39.
Setting on a desk/oor and
J
projecting from front
Setting on a desk/oor and
J
projecting from rear
INSTALLATION: FRONT/DESK INSTALLATION: REAR/DESK
Mounting on the ceiling and
J
projecting from front
Mounting on the ceiling and
J
projecting from rear
INSTALLATION: FRONT/CEILING INSTALLATION: REAR/CEILING
NOTE:
A translucent screen is required for rear projection. •
When mounting the projector on the ceiling, the optional ceiling mount bracket (ET-PKE2000, ET-PKE1000S) is required. •
See “Ceiling mount bracket safeguards” in “Technical Information” of the operating instructions. •
Front leg adjusters and throwing angle
You can screw up/down the front leg adjusters to control the angle of the projector for adjusting the throwing angle.
See “Positioning the image” on page 12.
NOTE:
Heated air comes out of the air exhaust port. Do not touch the air exhaust port directly. •
If keystone distortion occurs, see “KEYSTONE” on page • 34.
Screw up the front leg adjusters, and an audible click will be heard as the limit. •
To Next Page
Loading...
