WSS
WSS (Wide Screen Signalling) detects if a PAL/
625p (576p)/625i (576i) signal is input and that signal
has an identication signal, and switch the aspect ratio
to required setting automatically. You can switch the
system off manually. (Available with VIDEO/S-VIDEO/
COMPONENT signals only)
OVER SCAN
If the 4 edges of an image is partly dropped, you can
use this function to adjust and project it properly.
Setting range: 0 to +10
OVER SCAN
is not available with COMPUTER
signals.
Shrink Enlarge
KEYSTONE
If the projector is aligned non-perpendicularly to the
screen, or if the projection screen has an angled
surface, you can correct the keystone vertically.
Image Operation
Setting range: −32 to +32
NOTE:
You can correct the distortion ± 30 degrees from the •
vertical plane. For a better quality image, installing the
projector with minimum distortion is recommended.
Some distortion may be retained for the lens shift •
adjustment.
The distortion of the main menu screen is not •
correctable.
The result of the keystone correction will affect the •
aspect ratio and the size of the image.
AUTO SETUP
You can adjust V-POSITION, H-POSITION, DOT
CLOCK and CLOCK PHASE automatically when the
computer signal is detected. Press the ENTER button
to adjust these at the same time.
To Next Page
Loading...
