Panasonic PT-D9510E

78
ENGLISH
Operating procedure
Press the MENU button. ... The MENU screen will be displayed.
Press the UP ( ) and DOWN ( ) arrow buttons to select OPTION.
Press the ENTER button. ... The OPTION screen will be displayed.
Press the UP ( ) and DOWN ( ) arrow buttons to select NETWORK
MODULE SETTING.
Press the ENTER button. ... NETWORK MODULE SETTING screen will be
displayed.
Press the UP ( ) and DOWN ( ) arrow buttons to select each item and
press the ENTER button to change the setting.(refer to next page)
Press the UP ( ) and DOWN ( ) arrow buttons to select STORE and
press the ENTER button twice.
• After the online lamp of the network module goes out, it lights up again.
MENU
AUTO SETUP
LENS
PICTURE
POSITION
OPTION
SIGNALLIST
TEST PATTERN
MENU :
EXIT : MENU
Initial setting of network module
NETWORKMODULESETTING
HOSTNAME:PROJ01
DHCP :OFF
IPADDR:192.168.0.8
NETMASK :255.255.255.0
GATEWAY :192.168.0.1
MACADDR :01-02-03-
04-05-06
STORE
MENU :
POSITION :
ADJUST :0-9
EXIT:MENU
OPTION
SET RUNTIME :nnnnnh
LAMP POWER :＊＊＊＊＊＊
CONTRAST MODE :＊＊
RS-232C SETTING
SYSTEM INFORMATION
VIDEOMODULESETTING
NETWORKMODULESETTING
PASSWORD
MENU :
SUBMENU : ENTER
EXIT : MENU
• It takes about 2 minutes for settings to take effect.
• Do not turn off the main power supply until the online lamp of the network
module lights up again.
NOTE