Panasonic PT-RQ22K

Chapter 4 Settings — [DISPLAY OPTION] menu
130 - ENGLISH
3) Press as to select [SINGLE LINK SETTING], [DUAL LINK SETTING], or [QUAD LINK SETTING], and
press the <ENTER> button.
f The [SINGLE LINK SETTING] screen, the [DUAL LINK SETTING] screen, or the [QUAD LINK SETTING]
screen is displayed.
f When [QUAD LINK SETTING] is selected, proceed to Step 5).
4) Press as to select [SDI1], [SDI2], [SDI3], [SDI4], [SDI1-2], or [SDI3-4], and press the <ENTER> button.
f The [SINGLE LINK SETTING] or [DUAL LINK SETTING] screen of the selected item is displayed.
5) Press as to select [3G-SDI MAPPING].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Automatically select [LEVEL A] or [LEVEL B].
[LEVEL A] Fixes the mapping method to 3G-SDI Level-A.
[LEVEL B] Fixes the mapping method to 3G-SDI Level-B.
Note
f This does not operate when the SD-SDI signal or the HD-SDI signal is input.
f [3G-SDI MAPPING] cannot be set when [SDI LINK] is set to [AUTO].
Setting [SYSTEM SELECTOR] in [SDI IN]
1) Press as to select [SDI IN].
2) Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3) Press as to select [SINGLE LINK SETTING], [DUAL LINK SETTING], or [QUAD LINK SETTING], and
press the <ENTER> button.
f The [SINGLE LINK SETTING] screen, the [DUAL LINK SETTING] screen, or the [QUAD LINK SETTING]
screen is displayed.
f When [QUAD LINK SETTING] is selected, proceed to Step 5).
4) Press as to select [SDI1], [SDI2], [SDI3], [SDI4], [SDI1-2], or [SDI3-4], and press the <ENTER> button.
f The [SINGLE LINK SETTING] or [DUAL LINK SETTING] screen of the selected item is displayed.
5) Press as to select [SYSTEM SELECTOR].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Automatically selects [RGB], [YP
B
P
R
4:4:4], [YP
B
P
R
4:2:2], or [XYZ].
[RGB] Fixes to [RGB].
[YP
B
P
R
4:4:4] Fixes to [YP
B
P
R
4:4:4].
[YP
B
P
R
4:2:2] Fixes to [YP
B
P
R
4:2:2].
[XYZ] Fixes to [XYZ].
Setting [BIT DEPTH] in [SDI IN]
1) Press as to select [SDI IN].
2) Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3) Press as to select [SINGLE LINK SETTING], [DUAL LINK SETTING], or [QUAD LINK SETTING], and
press the <ENTER> button.
f The [SINGLE LINK SETTING] screen, the [DUAL LINK SETTING] screen, or the [QUAD LINK SETTING]
screen is displayed.
f When [QUAD LINK SETTING] is selected, proceed to Step 5).