Panasonic PT-RQ22K

Chapter 7 Appendix — Specications
278 - ENGLISH
Specications
The specications of the projector are as follows.
Power supply
100 V - 120 V / 200 V - 240 V ~ (100 V - 120 V / 200 V - 240 V alternating current), 50 Hz/60 Hz
Power consumption 960 W (9.8 A)/1 650 W (8.5 A)
Power consumption (during
standby)
When [STANDBY MODE] is set to [ECO]: 0.3 W
When [STANDBY MODE] is set to [NORMAL]: 4 W
DLP chip
Size 22.9 mm (0.90") (aspect ratio 16:10)
Display system DLP chip x 3, DLP projection system
Number of pixels 4 096 000 pixels (2 560 x 1 600 dots)
Lens Optional
Light source Laser x 2
Light output
20 000 lm
*1*3
, 21 000 lm (center)
*2*3
(When [OPERATING MODE] is set to [NORMAL])
Center to corner zone ratio
*1
90 %
Contrast ratio
*1
20 000:1 (when [DYNAMIC CONTRAST] is set to [3])
Projected image size 1.78 m (70") to 25.40 m (1 000")
*4
Image aspect ratio 16:10
Projection method [FRONT/CEILING], [FRONT/FLOOR], [REAR/CEILING], [REAR/FLOOR]
Power cord length 3.0 m (118-1/8")
Outer case Molded plastic
Outer color Black
Dimensions
Width 598 mm (23-17/32") (excluding protrusions)
Height
307 mm (12-3/32") (with the feet at shortest position)
270 mm (10-5/8") (excluding the feet and protrusion)
Depth 725 mm (28-17/32") (excluding the protrusion)
Weight
Approx. 54 k] (119 lbs.)
*5
Noise level
*1
46 dB
Operating
environment
Operating
environment
temperature
0 °C (32 °F) to 45 °C (113 °F)
*6*7
Operating
environment
humidity
10 % to 80 % (no condensation)
Remote
control
Power supply DC 3 V (AA/R6/LR6 battery x 2)
Operating range Within approx. 30 m (98'5") (when operated directly in front of signal receiver)
Weight
150 ] (5.3 ozs.) (including batteries)
Dimensions Width: 47.5 mm (1-7/8"), Height: 181.5 mm (7-5/32"), Depth: 27.5 mm (1-3/32")
*1 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118:2012 international standards.
*2 The value of the light output at the center region of the projected image is extracted based on the light output measurement method dened by the
ISO/IEC 21118:2012 international standards.
*3 When a projection lens other than ET-D75LE95, ET-D75LE90 is used with the power supply voltage of AC 200 V.
*4 When the Zoom Lens (Model No.: ET-D75LE8, ET-D3LET80) is used, the projected image size for the maximum projection distance will be 1.78 m
(70") to 15.24 m (600"). When the Fixed-focus Lens (Model No.: ET-D75LE95, ET-D75LE90) is used, the projected image size for the maximum
projection distance will be 3.05 m (120") to 15.24 m (600").
*5 Average value. Weight varies for each product.
*6 The operating environment temperature should be between 0 °C (32 °F) and 40 °C (104 °F) if the projector is used at an altitude between 1 400 m
(4 593') and 4 200 m (13 780') above sea level.
*7 When the [PROJECTOR SETUP] menu → [OPERATION SETTING] → [OPERATING MODE] is set to [NORMAL] or [ECO], and the operating
environment temperature exceeds the following value, the light output may be reduced to protect the projector.
f When using the projector at an altitude lower than 2 700 m (8 858') above sea level: 35 °C (95 °F)
f When using the projector at an altitude between 2 700 m (8 858') and 4 200 m (13 780') above sea level: 25 °C (77 °F)
Note
f The light output will decrease to approximately 1/2 when using the projector with AC 100 V to AC 120 V.
f The model numbers of accessories and optional accessories are subject to change without prior notice.