Panasonic PT-RQ22K

Chapter 1 Preparation — Precautions for use
22 - ENGLISH
Cautions when setting up the projector
f Install the projector in a place or with a mount that can sufciently tolerate the weight. The position of the
projected image may shift if the strength is not sufcient.
f Use the adjustable feet only for the oor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f The adjustable feet can be removed if not needed in the installation. However, do not use the screw holes
where the adjustable feet were removed to x the projector to a mount.
Also, do not attach any screws not instructed in the operating instructions of the optional accessories into the
screw holes where the adjustable feet are removed. Doing so may damage the projector.
f When using the projector in any method other than the oor installation using the adjustable feet or ceiling
mounting installation using the Ceiling Mount Bracket, remove the four adjustable feet and use the six screw
holes (as shown in the gure) to x the projector to a mount.
f Use a torque screwdriver or Allen torque wrench to tighten the xing screws to their specied tightening torques.
Do not use electric screwdrivers or impact screwdrivers.
(Screw diameter: M6, tapping depth inside the projector: 27 mm (1-1/16"), screw tightening torque: 4 ± 0.5 N·m)
Positions of screw holes to fix projector and
adjustable feet
Screw tightening torque: (M6) 4 ± 0.5 N·m
Adjustable feet
Embedded nut
Screw hole maximum
depth
27 (1-1/16") 10 (13/32")
Embedded nut (thread
engagement depth)
M6
27 (1-1/16")
Mount
M6
Thread engagement depth
Screw holes to fix the projector
Unit: mm
Adjustable feet